Thanks

Hello, Baldwin 9-1-1, and thanks for your interest in map editing with OSM. Just a couple of suggestions...please do not use all caps for the street name and spell out any abbreviations, i.e. Landing Drive.

Here are a couple of pages in the Wiki that will be helpful: osm.wiki/Good_practice#Do_correct_errors

osm.wiki/Editing_Standards_and_Conventions

Please don't anymore roads until you align the satellite imagery properly. osm.wiki/Using_Imagery
---

Published using OSMCha: https://osmcha.org/changesets/83491011

Please don't attach the driveway to the house. Just bring it close but not touching. Thanks.

Also don't put "House" as the name. Ordinarily private residences don't have names. But you can add the address (house number, street, town, state, zip code) if you want.Thanks.

Hello, Dajah Drummond, and thanks for your interest in map editing with OSM. Just a suggestion... houses usually have square corners so you can square up the ones you created by selecting a house and then pressing the Q key. Makes them look much neater! As a new editor you may want to read this Wiki page: osm.wiki/Good_practice#Do_correct_errors

Thanks for your edits. Just a suggestion...don't let landuse areas "snap-to" roads. If the road needs to be edited at a later time, it can add a lot of work to "unglue" the land area. Just zoom in and bring the landuse area close to, but not touching the road. Thanks.

Thanks for fixing those houses! Good work.

I reverted this changeset but you may have to fix a couple of houses. You'll have to fix the other changesets sets too.

Here's some good reading: osm.wiki/Good_practice#Do_correct_errors

Hello, ComfortablySore, and thanks for your interest in map editing with OSM. We're always happy to see good editors and edits. I was curious why it would be necessary to add nodes to a street that is perfectly straight? It won't cause any harm but you may want to read this page in the Wiki about good practices where straight streets are mentioned: osm.wiki/Good_practice#Do_correct_errors

This changeset has been partially reverted in changeset/83481701 to restore data that should not have been deleted.
---
#REVIEWED_BAD #OSMCHA
Published using OSMCha: https://osmcha.org/changesets/83414429

This changeset has been partially reverted in changeset/83481315 to restore data that should not have been deleted.
---
#REVIEWED_BAD #OSMCHA
Published using OSMCha: https://osmcha.org/changesets/83414971

Thanks for your edits. Just a tip...you can square up the corners of buildings by selecting the building and pressing the Q key. Makes them look much neater. Thanks.

Thanks for your edits, but before you move a lot of streets you may want to make sure the satellite imagery you are using is aligned to the existing street in the area. Please read this Wiki page: osm.wiki/Using_Imagery

Thanks for your edit but please leave comments that describe your edit a little better. Here'e the Wiki page about that: osm.wiki/Good_changeset_comments Thanks.

Hello, DavidFleming, and thanks for your interest in map editing with OSM. Good edits (and editors) are always welcome. Your house numbers aren't showing up on the map so you may want to review this page in the Wiki: addr=*

This changeset was reverted in changeset/83477224 due to vandalism.
---
#REVIEWED_BAD #OSMCHA
Published using OSMCha: https://osmcha.org/changesets/83476045

No problem. Believe me, I did exactly the same thing when I was a new editor. I'll revert your edits so you can start fresh. Happy mapping! If you have questions, and you can't find the answer in the Wiki, don't hesitate to ask. Thanks.

Please don't delete roads unless they actually do not exist. If there is a gate closing off part of a road, then just add the gate but don't delete the rest of the road. Traffic that is allowed through the gate may use the service roads past the gate. This changeset is being reverted.

Thanks for adding the park but you might want to adjust it to include just the park area and not the parking area around it.