See the discussion at note/4962437

Apparently RapiD also truncates changeset comments instead of warning you about the character limit :(

Added addresses to the duplexes on Algonquin and Amelia Drives in Cedar Falls, IA. Each building shares a single house number, and each unit has a unit number. This is really unusual for Cedar Falls (usually each unit in a duplex has its own house number), so I confirmed with a survey before adding the data from ESRI. Since RapiD has a 50-item limit, adding them all will take multiple changesets.

Hi sourcemaster,

ESRI's address database has this house numbered 2702, and the other houses on this side of the street have even numbers. Are you sure this house number should be 2701?

I will be over here in a few days to survey house numbers after I finish tracing the new houses on Arbor Ridge Road and Maple Grove Drive. I can check this too while I'm there, but it would be nice if we could resolve this first.

Thanks,

Feet and Inches

The bounding box ended up being large on this changeset because the sidewalks connect to bike paths that are quite long. The edits are all around the four businesses in the very northwest corner of the box.

I just drove by this and can confirm that the rack was there today.

Hi there! What did you want to be reviewed for this change? I am local to the area, so I could stop by and survey it. I just need to know what to look for. Thanks!

Hi there!

I am the person who originally traced this apartment building. Could you please explain why you deleted it and replaced it, and why you didn't replace any of the other apartments? Then I will know how to do it right the first time.

Thanks!

I requested for someone to review these edits to double check that RapiD data can be used in this way.

This is my first time adding a meaningful number of addresses, so I requested for someone to review the changes and make sure I did them properly.

See note/4748857

For reference, the previous service road was way/18084532. Also, I completely forgot to take a picture of the sign out front, so I can't add the name of the facility at this time and just mapped it as a generic building. Whoops.

Updated on changeset/153520410.